DIN 1472 — Grooved pins – Half-length taper grooved — ISO 8745
What is the din standard for DIN 1472 — Grooved pins – Half-length taper grooved — ISO 8745?
For DIN 1472, fastener description is Grooved pins – Half-length taper grooved; iso equivalent is 8745, verified against its source on 2026-08-12.
1472 | 8745 | 28745 | | 8745 | 1998-03 | Grooved pins – Half-length taper grooved | Nominal lengths redefined. Shear rate increased. |
— fullerfasteners.com, retrieved 2026-08-12
- DIN standard
- 1472 verified
- Fastener description
- Grooved pins – Half-length taper grooved verified
- ISO equivalent
- 8745 verified
- Interchangeability
- Nominal lengths redefined. Shear rate increased. verified
- Modification notes
- Nominal lengths redefined. Shear rate increased. verified
Sources disagree
More than one authority states this, and they do not state the same thing. Both are reproduced with the source each came from — deciding between them is yours, not ours.
Fastener description
fullerfasteners.com says fastener description is Grooved pins – Half-length taper grooved, as of 2026-08-12.
1472 | 8745 | 28745 | | 8745 | 1998-03 | Grooved pins – Half-length taper grooved | Nominal lengths redefined. Shear rate increased. |
https://fullerfasteners.com/tech/din-iso-en-crossover-chart/
trfastenings.com says fastener description is Grooved Pins, half length taper-grooved, as of 2026-08-12.
DIN 1472 | ISO 8745 | | Grooved Pins, half length taper-grooved |
https://www.trfastenings.com/knowledge-base/engineering-data/fastener-standards
Sources
- fullerfasteners.comhttps://fullerfasteners.com/tech/din-iso-en-crossover-chart/
- trfastenings.comhttps://www.trfastenings.com/knowledge-base/engineering-data/fastener-standards