GME40.06 - Stepped FEA finish
What is the specification type for GME40.06 - Stepped FEA finish?
For GME40.06 - Stepped FEA finish, specification type is neck_finish, recorded from its source on 2026-09-23.
This range of FEA glass neck finishes with sizes 18 and 20 are designated for aerosol dispensers. This document was established from the INE BV96037 data sheet. The step of 0,2 mm can be used for protecting the upper part of the plastic coating and integrating it under the crimped ferrule.
— cetie.org, retrieved 2026-09-23
- Specification ID
- GME40.06 - Stepped FEA finish our reading
- Specification type
- neck_finish our reading
- Description
- This range of FEA glass neck finishes with sizes 18 and 20 are designated for aerosol dispensers. This document was established from the INE BV96037 data sheet. The step of 0,2 mm can be used for protecting the upper part of the plastic coating and integrating it under the crimped ferrule. verified
Values marked our reading are our classification of what the source says — the source does not print them in those words. The quote below is the evidence for each one; judge it yourself.
Where each value comes from
The value above is stated away from the sentence quoted with the answer, so the passage that states it is shown here too.
Specification ID
GME40.06 - Stepped FEA finish
— all from cetie.org, retrieved 2026-09-23
Source
- cetie.orghttps://www.cetie.org/en/finish-data-sheets-gme_102.html