# GME40.06 - Stepped FEA finish — Packaging specification equivalence: neck finishes, corrugated grades and pallet standards

For GME40.06 - Stepped FEA finish, specification type is neck_finish, recorded from its source on 2026-09-23.

- **Specification ID:** GME40.06 - Stepped FEA finish _(our reading, not quoted from the source)_
- **Specification type:** neck_finish _(our reading, not quoted from the source)_
- **Description:** This range of FEA glass neck finishes with sizes 18 and 20 are designated for aerosol dispensers. This document was established from the INE BV96037 data sheet. The step of 0,2 mm can be used for protecting the upper part of the plastic coating and integrating it under the crimped ferrule. _(verified: appears in the quote below)_

## What the source says

> This range of FEA glass neck finishes with sizes 18 and 20 are designated for aerosol dispensers. This document was established from the INE BV96037 data sheet. The step of 0,2 mm can be used for protecting the upper part of the plastic coating and integrating it under the crimped ferrule.

## Where each value comes from

This source states these in separate places, so each value is shown with the passage that states it.

### Specification ID

> GME40.06 - Stepped FEA finish

## Source

- https://www.cetie.org/en/finish-data-sheets-gme_102.html

Last verified: 2026-09-23. Review by: 2028-09-22.
Part of [Packaging specification equivalence: neck finishes, corrugated grades and pallet standards](https://referencesource.org/packaging-material-specification-equivalence/).