End9 · GA800 · Auto-Tuning Error
For End9, model / series is GA800; type is Auto-Tuning Error; brand is Yaskawa; fault name is Initial Pole Detection Alarm; cause is The drive cannot calculate the correct value for n8-84 [Polarity Detection Current] during High Frequency Injection Tuning, verified against its source on 2026-10-10.
- Brand
- Yaskawa
- Model / series
- GA800
- Fault code
- End9 verified
- Fault name
- Initial Pole Detection Alarm verified
- Type
- Auto-Tuning Error verified
- Cause
- The drive cannot calculate the correct value for n8-84 [Polarity Detection Current] during High Frequency Injection Tuning. verified
- Corrective action
- • Set the correct value on the motor nameplate E5-xx [PM motor parameters] or do Stationary/Rotational Auto-Tuning, and then do High Frequency Injection Tuning again. • When n8-35 = 1 [Initial Pole Detection Method = High Frequency Injection] or n8-57 = 1 [HFI Overlap Selection = Enabled], make sure that the motor does not rotate in reverse at start. verified
What the source says
End9 Initial Pole Detection Alarm Flashing Auto-Tuning Error 142
— yaskawa.com, retrieved 2026-09-01
Where each value comes from
This source states these in separate places, so each value is shown with the passage that states it.
Cause
The drive cannot calculate the correct value for n8-84 [Polarity Detection Current] during High Frequency Injection Tuning.
Corrective action
• Set the correct value on the motor nameplate E5-xx [PM motor parameters] or do Stationary/Rotational Auto-Tuning, and then do High Frequency Injection Tuning again. • When n8-35 = 1 [Initial Pole Detection Method = High Frequency Injection] or n8-57 = 1 [HFI Overlap Selection = Enabled], make sure that the motor does not rotate in reverse at start.
— all from yaskawa.com, retrieved 2026-09-01
Source
- yaskawa.comhttps://www.yaskawa.com/delegate/getAttachment?documentId=TOEPYAIGA8001&cmd=documents&documentName=TOEPYAIGA8001.pdf