CyC · GA800 · Alarm
For CyC, model / series is GA800; type is Alarm; brand is Yaskawa; fault name is MECHATROLINK CommCycleSettingErr; cause is The communications cycle setting of the controller is not in the permitted range of the MECHATROLINK interface option, verified against its source on 2026-10-10.
- Brand
- Yaskawa
- Model / series
- GA800
- Fault code
- CyC verified
- Fault name
- MECHATROLINK CommCycleSettingErr verified
- Type
- Alarm verified
- Cause
- The communications cycle setting of the controller is not in the permitted range of the MECHATROLINK interface option. verified
- Corrective action
- Set the communications cycle of the controller in the permitted range of the MECHATROLINK interface option. verified
What the source says
CyC (0033) MECHATROLINK CommCycleSettingErr Flashing Alarm 126
— yaskawa.com, retrieved 2026-09-01
Where each value comes from
This source states these in separate places, so each value is shown with the passage that states it.
Cause
The communications cycle setting of the controller is not in the permitted range of the MECHATROLINK interface option.
Corrective action
Set the communications cycle of the controller in the permitted range of the MECHATROLINK interface option.
— all from yaskawa.com, retrieved 2026-09-01
Source
- yaskawa.comhttps://www.yaskawa.com/delegate/getAttachment?documentId=TOEPYAIGA8001&cmd=documents&documentName=TOEPYAIGA8001.pdf