Reference Source

float-scaffold-edging-minimum-dimensions

What is the paragraph citation for float-scaffold-edging-minimum-dimensions?

For float-scaffold-edging-minimum-dimensions, paragraph citation is 1926.451(h)(2)(ii); type of requirement is permitted alternative dimensions; value (imperial) is 3⁄4 × 11⁄2 inch; value (metric) is 2 × 4 cm; applies to is float (ship) scaffolds, recorded from its source on 2026-09-01; source re-checked 2026-09-14.

(ii) A toeboard shall be erected along the edge of platforms more than 10 feet (3.1 m) above lower levels for a distance sufficient to protect employees below, except on float (ship) scaffolds where an edging of 3⁄4 × 11⁄2 inch (2 × 4 cm) wood or equivalent may be used in lieu of toeboards;

ecfr.gov, retrieved 2026-09-01

Requirement ID
float-scaffold-edging-minimum-dimensions our reading
Paragraph citation
1926.451(h)(2)(ii) our reading
Type of requirement
permitted alternative dimensions our reading
Value (imperial)
3⁄4 × 11⁄2 inch verified
Value (metric)
2 × 4 cm verified
Applies to
float (ship) scaffolds verified
Regulation section heading
Falling object protection verified
Sourceecfr.gov
Verified
Review by
DatasetEvery numeric dimensional tolerance and safety factor in OSHA's scaffold general requirements (29 CFR 1926.451)

Values marked our reading are our classification of what the source says — the source does not print them in those words. The quote below is the evidence for each one; judge it yourself.

Where each value comes from

The value above is stated away from the sentence quoted with the answer, so the passage that states it is shown here too.

Regulation section heading

(h) Falling object protection.

— all from ecfr.gov, retrieved 2026-09-01

Source

Last verified against source: . Due for re-check by . This page as Markdown · OKF bundle · full dataset as JSON.