Reference Source

crawling-board-grabline-minimum-diameter

What is the paragraph citation for crawling-board-grabline-minimum-diameter?

For crawling-board-grabline-minimum-diameter, paragraph citation is 1926.451(g)(1)(iii); type of requirement is minimum diameter; value (imperial) is three-fourth inch; value (metric) is 1.9 cm; applies to is Each employee on a crawling board (chicken ladder), recorded from its source on 2026-08-31; source re-checked 2026-09-14.

(iii) Each employee on a crawling board (chicken ladder) shall be protected by a personal fall arrest system, a guardrail system (with minimum 200 pound toprail capacity), or by a three-fourth inch (1.9 cm) diameter grabline or equivalent handhold securely fastened beside each crawling board;

ecfr.gov, retrieved 2026-08-31

Requirement ID
crawling-board-grabline-minimum-diameter our reading
Paragraph citation
1926.451(g)(1)(iii) our reading
Type of requirement
minimum diameter our reading
Value (imperial)
three-fourth inch verified
Value (metric)
1.9 cm verified
Applies to
Each employee on a crawling board (chicken ladder) verified
Regulation section heading
Fall protection verified
Sourceecfr.gov
Verified
Review by
DatasetEvery numeric dimensional tolerance and safety factor in OSHA's scaffold general requirements (29 CFR 1926.451)

Values marked our reading are our classification of what the source says — the source does not print them in those words. The quote below is the evidence for each one; judge it yourself.

Where each value comes from

The value above is stated away from the sentence quoted with the answer, so the passage that states it is shown here too.

Regulation section heading

(g) Fall protection.

— all from ecfr.gov, retrieved 2026-08-31

Source

Last verified against source: . Due for re-check by . This page as Markdown · OKF bundle · full dataset as JSON.