Automatic weighing instruments · Annex VIII · discontinuous totaliser, totalised load, class 0,5
For Automatic weighing instruments, annex is Annex VIII; condition is discontinuous totaliser, totalised load, class 0,5; accuracy class is 0,5; maximum permissible error is ± 0,25 %, recorded from its source on 2026-09-01.
- Instrument type
- Automatic weighing instruments verified
- Annex
- Annex VIII verified
- Accuracy class
- 0,5 verified
- Condition
- discontinuous totaliser, totalised load, class 0,5 our reading
- Maximum permissible error
- ± 0,25 % verified
Values marked our reading are our classification of what the source says — the source does not print them in those words. The quote below is the evidence for each one; judge it yourself.
What the source says
CHAPTER IV Discontinuous Totalisers 1. Accuracy Classes Instruments are divided into four accuracy classes as follows: 0,2; 0,5; 1; 2. 2. MPEs Table 6 Accuracy class | MPE of totalised load | 0,2 | ± 0,10 % | 0,5 | ± 0,25 % | 1 | ± 0,50 % | 2 | ± 1,00 % | 3. Totalisation scale interval
— eur-lex.europa.eu, retrieved 2026-09-01
Where each value comes from
This source states these in separate places, so each value is shown with the passage it comes from.
Instrument type
ANNEX VIII AUTOMATIC WEIGHING INSTRUMENTS (MI-006) The relevant essential requirements of Annex I, the specific requirements of this Annex and the conformity assessment procedures listed in Chapter I of this Annex, apply to automatic weighing instruments defined below, intended to determine the mass of a body by using the action of gravity on that body.
Annex
ANNEX VIII AUTOMATIC WEIGHING INSTRUMENTS (MI-006)
Accuracy class
The source prints this value inside the passage below but does not name it there. The passage shows where it appears; what ties it to this record is the position on the page, not anything the passage says.
CHAPTER IV Discontinuous Totalisers 1. Accuracy Classes Instruments are divided into four accuracy classes as follows: 0,2; 0,5; 1; 2. 2. MPEs Table 6 Accuracy class | MPE of totalised load | 0,2 | ± 0,10 % | 0,5
Maximum permissible error
CHAPTER IV Discontinuous Totalisers 1. Accuracy Classes Instruments are divided into four accuracy classes as follows: 0,2; 0,5; 1; 2. 2. MPEs Table 6 Accuracy class | MPE of totalised load | 0,2 | ± 0,10 % | 0,5 | ± 0,25 %
— all from eur-lex.europa.eu, retrieved 2026-09-01
Source
- eur-lex.europa.euhttps://eur-lex.europa.eu/legal-content/EN/TXT/HTML/?uri=CELEX:32014L0032