Scales · class III L, test load 0 to 500 e, maintenance tolerance

For Scales, condition is class III L, test load 0 to 500 e, maintenance tolerance; accuracy class is III L; maximum permissible error is 1; scope or member state option is Add 1 e for each additional 500 e or fraction thereof (Only applies to Class III L), recorded from its source on 2026-10-13.

Values marked our reading are our classification of what the source says — the source does not print them in those words. The quote below is the evidence for each one; judge it yourself.

What the source says

Accuracy class

The source prints this value inside the passage below but does not name it there. The passage shows where it appears; what ties it to this record is the position on the page, not anything the passage says.

Table 6. Maintenance Tolerances (All values in this table are in verification scale intervals (e)) Tolerance 1 2 3 5 Class Test Load Applied I 0 to 50 000 50 001 to 200 000 200 001 + II 0 to 5 000 5 001 to 20 000 20 001 + III 0 to 500 501 to 2 000 2 001 to 4 000 4 001 + IIII 0 to 50 51 to 200 201 to 400 401 + III L 0 to 500 501 to 1 000 Add 1 e for each additional 500 e or fraction thereof (Only applies to Class III L)

— nist.gov, retrieved 2026-10-13

Where each value comes from

This source states these in separate places, so each value is shown with the passage that states it.

— all from nist.gov, retrieved 2026-10-13

Source

• nist.govhttps://www.nist.gov/document/2026-nist-handbook-44-section-220

Last verified against source: 2026-10-13. Due for re-check by 2027-10-13. This page as Markdown · OKF bundle · full dataset as JSON.