Reference Source

DIN 966

For DIN 966, iso standard is ISO 7047; part is Cross Recessed Raised Countersunk; interchangeability verdict is Check spec, verified against its source on 2026-08-05.

DIN standard
DIN 966 verified
ISO standard
ISO 7047 verified
Part
Cross Recessed Raised Countersunk verified
Interchangeability verdict
Check spec verified
Sourcemonsterbolts.com
Verified2026-08-05
Review by2029-08-04
DatasetDIN / ISO / BS fastener equivalents and the sizes where they are not interchangeable

What the source says

Cross Recessed Raised Countersunk | DIN 966 | ISO 7047 | Check spec | Raised profile/diameter tolerance.

— monsterbolts.com, retrieved 2026-08-05

Sources disagree

More than one authority states this, and they do not state the same thing. Both are reproduced with the source each came from — deciding between them is yours, not ours.

Part

monsterbolts.com says part is Cross Recessed Raised Countersunk, as of 2026-08-05.

Cross Recessed Raised Countersunk | DIN 966 | ISO 7047 | Check spec | Raised profile/diameter tolerance.

https://monsterbolts.com/pages/common-din-numbers-for-metric-fasteners

trfastenings.com says part is Cross Recessed Raised Countersunk Head Screws, as of 2026-08-05.

DIN 966 | ISO 7047 | | Cross Recessed Raised Countersunk Head Screws |

https://www.trfastenings.com/knowledge-base/engineering-data/fastener-standards

Sources

Last verified against source: 2026-08-05. Due for re-check by 2029-08-04. This page as Markdown · OKF bundle · full dataset as JSON.