# max-distance-to-work-face-outrigger — Every numeric dimensional tolerance and safety factor in OSHA's scaffold general requirements (29 CFR 1926.451)

For max-distance-to-work-face-outrigger, paragraph citation is 1926.451(b)(3)(i); type of requirement is maximum gap; value (imperial) is 3 inches; value (metric) is 8 cm; applies to is outrigger scaffolds, recorded from its source on 2026-08-31; source re-checked 2026-09-14.

- **Requirement ID:** max-distance-to-work-face-outrigger _(our reading, not quoted from the source)_
- **Paragraph citation:** 1926.451(b)(3)(i) _(our reading, not quoted from the source)_
- **Type of requirement:** maximum gap _(our reading, not quoted from the source)_
- **Value (imperial):** 3 inches _(verified: appears in the quote below)_
- **Value (metric):** 8 cm _(verified: appears in the quote below)_
- **Applies to:** outrigger scaffolds _(verified: appears in the quote below)_
- **Regulation section heading:** Scaffold platform construction _(verified: appears in its own passage below)_

## What the source says

> (i) The maximum distance from the face for outrigger scaffolds shall be 3 inches (8 cm);

## Where each value comes from

This source states these in separate places, so each value is shown with the passage that states it.

### Regulation section heading

> (b) Scaffold platform construction.

## Source

- https://www.ecfr.gov/current/title-29/subtitle-B/chapter-XVII/part-1926/subpart-L/section-1926.451

Last verified: 2026-09-14. Review by: 2027-08-31.
Part of [Every numeric dimensional tolerance and safety factor in OSHA's scaffold general requirements (29 CFR 1926.451)](https://referencesource.org/osha-scaffold-dimensional-tolerances/).