# fall-protection-trigger-height — Every numeric dimensional tolerance and safety factor in OSHA's scaffold general requirements (29 CFR 1926.451)

For fall-protection-trigger-height, paragraph citation is 1926.451(g)(1); type of requirement is trigger height; value (imperial) is 10 feet; value (metric) is 3.1 m; applies to is Each employee on a scaffold, recorded from its source on 2026-08-31; source re-checked 2026-09-14.

- **Requirement ID:** fall-protection-trigger-height _(our reading, not quoted from the source)_
- **Paragraph citation:** 1926.451(g)(1) _(our reading, not quoted from the source)_
- **Type of requirement:** trigger height _(our reading, not quoted from the source)_
- **Value (imperial):** 10 feet _(verified: appears in the quote below)_
- **Value (metric):** 3.1 m _(verified: appears in the quote below)_
- **Applies to:** Each employee on a scaffold _(verified: appears in the quote below)_
- **Regulation section heading:** Fall protection _(verified: appears in its own passage below)_

## What the source says

> (1) Each employee on a scaffold more than 10 feet (3.1 m) above a lower level shall be protected from falling to that lower level.

## Where each value comes from

This source states these in separate places, so each value is shown with the passage that states it.

### Regulation section heading

> (g) Fall protection.

## Source

- https://www.ecfr.gov/current/title-29/subtitle-B/chapter-XVII/part-1926/subpart-L/section-1926.451

Last verified: 2026-09-14. Review by: 2027-08-31.
Part of [Every numeric dimensional tolerance and safety factor in OSHA's scaffold general requirements (29 CFR 1926.451)](https://referencesource.org/osha-scaffold-dimensional-tolerances/).