DIN 7983
For DIN 7983, iso standard is ISO 7051; part is Cross Recessed Raised Countersunk Tapping; interchangeability verdict is Check spec, verified against its source on 2026-08-05.
- DIN standard
- DIN 7983 verified
- ISO standard
- ISO 7051 verified
- Part
- Cross Recessed Raised Countersunk Tapping verified
- Interchangeability verdict
- Check spec verified
What the source says
Cross Recessed Raised Countersunk Tapping | DIN 7983 | ISO 7051 | Check spec | Raised profile tolerance.
— monsterbolts.com, retrieved 2026-08-05
Sources disagree
More than one authority states this, and they do not state the same thing. Both are reproduced with the source each came from — deciding between them is yours, not ours.
Part
monsterbolts.com says part is Cross Recessed Raised Countersunk Tapping, as of 2026-08-05.
Cross Recessed Raised Countersunk Tapping | DIN 7983 | ISO 7051 | Check spec | Raised profile tolerance.
https://monsterbolts.com/pages/common-din-numbers-for-metric-fasteners
trfastenings.com says part is Countersunk (flat) Head Tapping Screws with cross recess, as of 2026-08-05.
DIN 7983 | ISO 7051 | | Countersunk (flat) Head Tapping Screws with cross recess |
https://www.trfastenings.com/knowledge-base/engineering-data/fastener-standards
Sources
- monsterbolts.comhttps://monsterbolts.com/pages/common-din-numbers-for-metric-fasteners
- trfastenings.comhttps://www.trfastenings.com/knowledge-base/engineering-data/fastener-standards