DIN 7981
For DIN 7981, iso standard is ISO 7049; part is Cross Recessed Pan Head Tapping; interchangeability verdict is Check spec, verified against its source on 2026-08-05.
- DIN standard
- DIN 7981 verified
- ISO standard
- ISO 7049 verified
- Part
- Cross Recessed Pan Head Tapping verified
- Interchangeability verdict
- Check spec verified
What the source says
Cross Recessed Pan Head Tapping | DIN 7981 | ISO 7049 | Check spec | Head/point differences.
— monsterbolts.com, retrieved 2026-08-05
Sources disagree
More than one authority states this, and they do not state the same thing. Both are reproduced with the source each came from — deciding between them is yours, not ours.
Part
monsterbolts.com says part is Cross Recessed Pan Head Tapping, as of 2026-08-05.
Cross Recessed Pan Head Tapping | DIN 7981 | ISO 7049 | Check spec | Head/point differences.
https://monsterbolts.com/pages/common-din-numbers-for-metric-fasteners
trfastenings.com says part is Cross Recessed Pan Head Tapping Screws, as of 2026-08-05.
DIN 7981 | ISO 7049 | | Cross Recessed Pan Head Tapping Screws |
https://www.trfastenings.com/knowledge-base/engineering-data/fastener-standards
Sources
- monsterbolts.comhttps://monsterbolts.com/pages/common-din-numbers-for-metric-fasteners
- trfastenings.comhttps://www.trfastenings.com/knowledge-base/engineering-data/fastener-standards